20
10.2 Installing the energy supply
NOTICE
Installation of voltage supply is done internally. This means that the MATCH gripper is equipped with internal
contacts. These contacts transmit all signals.
►
The contacts of the energy supply must be dry, clean and undamaged at all times.
Ö
Damage to the contacts can result in malfunction of the product.
10.3 Static charge
CAUTION
Non-compliance may result in material damage.
Grounding the product is recommended if ESD sensitive parts come into contact with the product.
Grounding is also recommended in applications that require high EMC shielding.
The movement of the gripper jaws creates low voltages as a result of static charging. These charges cannot be dissipated if
the product is mounted on an insulating surface and if discharge is also not possible through the workpiece.
10.4 Heat dissipation
In the event of high ambient temperatures, the product must be installed on heat-dissipating materials.
If the product is operated under very high ambient temperatures and with fast clock cycles on an ongoing basis, this might
reduce its service life.
INFORMATION
Ö
The cycle time must therefore be reduced as the temperature increases.
10.5 Installing accessories
NOTICE
Before installing an accessory, make sure it is suitable for use with the selected variant.
►
You can find information on our website.
►
Please contact Zimmer Customer Service if you have any questions.
INSTALLATION AND OPERATING INSTRUCTIONS:
LWR50L-24/-25
DDOC01073 / -
EN / 2022-07-20
Zimmer GmbH • Im Salmenkopf 5 •
77866 Rheinau, Germany •
+49 7844 9138 0 • www.zimmer-group.com
