INSTALLATION AND OPERATING INSTRUCTIONS:
Motor spindle, HF150-003 series
Zimmer GmbH
•
Im Salmenkopf 5
•
77866 Rheinau, Germany
•
+49 7844 9138 0
•
+49 7844 9138 80
•
www.zimmer-group.com
34
EN / 2020-10-22
DDOC00746 / -
13 Disassembly for decommissioning
This section describes how to disassemble the product from the superordinate machine or system.
The following work steps must be observed during disassembly:
►
Switch off the power supply of the machine or system (main switch).
►
Switch off the power supply of the motor spindle.
►
Disconnect the power supply lines from the motor spindle.
►
Remove the motor spindle from the mounting piece.
Ö
Ensure that the working environment is safe!
Ö
Use hoisting tools!
Ö
Wear personal protective equipment!
14 Decommissioning and disposal
INFORMATION:
When the motor spindle reaches the end of its operational phase, it can be completely disassembled and
disposed of.
Completely disconnect the motor spindle from the power supply. The motor spindle can be disassembled and
properly disposed of according to material groups.
When disposing of it, observe the locally applicable environmental regulations and codes and regulations for
disposal.
If it is not possible to properly disassemble and dispose the motor spindle, the motor spindle can also be sent
back to Zimmer GmbH.
Zimmer Customer Service is available to provide you with assistance if you have any further questions.
15 Cleaning/preservation
NOTICE:
Dispose rags that have absorbed oil and grease in an environmentally responsible way!
When disposing them, observe the locally applicable environmental regulations and codes and regulations for
disposal.
►
Before preservation, clean the motor spindle to remove any dirt and dust.
►
The motor spindle must be thoroughly cleaned.
►
The complete motor spindle must be provided with corrosion protection.