8
10 Installation
WARNING
Risk of injury due to uncontrolled movements
Risk of injury in case of unexpected movement of the machine or system into which the product is to be installed.
►
Switch off the energy supply of the machine before any work.
►
Secure the power supply against being switched on unintentionally.
►
Check the machine for any residual energy that may be present.
►
For spring-assisted products, wait until the gripper jaws reach the end position with the system depressurized.
CAUTION
Risk of injury due to uncontrolled movements
Risk of injury in the event of uncontrolled movement of the product when the power supply is connected.
►
Switch off the power supply to the machine before carrying out any work.
►
Secure the power supply against being switched on unintentionally.
►
Check the machine for any residual energy that may be present.
NOTICE
►
Installation may only be carried out by qualified personnel in accordance with these installation and operating
instructions.
►
Switch off the power supply before any assembly, installation or maintenance work.
►
Install the product on an appropriate mounting surface in accordance with the flatness specifications.
INFORMATION
Requirements for a mounting surface with a length < 100 mm:
• Permissible unevenness [mm]: 0.02
Requirements for a mounting surface with a length > 100 mm:
• Permissible unevenness [mm]: 0.05
Further installation information:
• The mounting screws are not included in the scope of delivery.
• Strength class of the mounting screws 8.8 (DIN EN ISO 4762)
►
Make sure that the mounting piece is sufficiently rigid.
►
Observe the tightening torque of the mounting screws.
►
Verify the permitted load capacity of the required screw connections in accordance with VDI 2230.
Zimmer GmbH • Im Salmenkopf 5 •
77866 Rheinau, Germany •
+49 7844 9138 0 • www.zimmer-group.com
INSTALLATION AND OPERATION INSTRUCTIONS:
GHK6000
DDOC00313 / a
EN / 2023-02-13
Summary of Contents for GHK6000
Page 2: ......
