7
6 Functional description
The housing is pressurized with pneumatic pressure which sets two opposite pistons into motion. These each put pressure
on pretensioned disk springs and deflects them.
The inner diameter of the product increases slightly from this and releases the shaft.
The product is closed in a pressureless state that ensures that all moving components are held securely if the pressure
drops or the entire system fails.
1
Case
2
Clamping area
1
2
7 Technical data
INFORMATION
• B10d value: 3 million cycles
INFORMATION
►
You can find the information in the technical data sheet on our website.
This data varies within the series, depending on the specific design.
►
Please contact Zimmer Customer Service if you have any questions.
INFORMATION
The holding torque is specified in the technical data sheet.
•
The accuracy of the specified holding torque corresponds to an installation size-independent tangential
motion of the shaft of 2 µm under load.
• The maximum holding torque corresponds to the maximum holding torque that may be applied to the product
during safety operating mode or an emergency stop.
• The maximum holding torque can also be used for applications for which angle accuracy is not required.
INSTALLATION AND OPERATING INSTRUCTIONS:
DKPS1000
DDOC01621 / a
EN / 2022-10-04
Zimmer GmbH • Im Salmenkopf 5 •
77866 Rheinau, Germany •
+49 7844 9138 0 • www.zimmer-group.com
Summary of Contents for DKPS1000 Series
Page 2: ......
