ZIMM ZA-25, Instruction Manual

Page: 21 / 37

ZIMM Actuator 6 Installation
2023 Version 0.6 21
HINWEIS

Make sure that the mechanism that is actuated can move
along the entire stroke path.

Run the screw jack over the complete travel in both directions.
When doing this, comply with the following:
– Run the screw jack slowly and carefully.
– As far as possible, run it with no load or with only a small load.
– Current consumption should be within the normal range, and
should be constant.
Major fluctuations indicate alignment errors and stresses.
– Monitor the temperature and avoid overheating, especially
where the travel is long and multiple runs are performed
successively.
– Avoid overrunning the limit switch (optional).