ZIMM ZA-25, Instruction Manual

Page: 19 / 37

ZIMM Actuator 6 Installation
2023 Version 0.6 19
6.3 Fitting the motor

The ZIMM Actuator must be installed.
CAUTION
Moving parts!
Injuries due to rotating parts.

Switch off the entire system and secure it against switching on again.
Fig. 13: Installing the motor
1. Fit the motor flange (1) to the ZIMM Actuator and bolt it into place.
2. Fit the coupling halves (2) to the gearbox shaft and bolt them into
place.
3. Attach the coupling star (3).
4. Pull the motor-side coupling halves (4) on to the motor shaft.
5. Attach the motor (5) to the motor flange and bolt it into place.
6. Fit the motor-side coupling halves (6) as follows:
– Slide them on to the gearbox-side coupling halves, leaving
1 mm axial play.
– Tighten the securing bolt (7).
– If the coupling halves cannot be slid on to the motor shaft:
Adjust the position before step 5 and tighten them.
7. Seal the assembly opening in the motor flange with a suitable
covering material.