ZiLOG Zdots eZ80AcclaimPlus, User Manual

Page: 16 / 34

The eZ80AcclaimPlus! Development Kit UM024401-0412
6
eZ80AcclaimPlus! Development Kit
User Manual
Windows XP Systems
Observe the following steps to install the USB Smart Cable on a Windows XP system.
1. Connect the USB Smart Cable to a USB port on the development PC. When the PC
detects the new hardware, it will display the Found New Hardware Wizard dialog.
2. In the Wizard, select Install from a list or specific location (Advanced) , and click Next .
If the Windows Hardware Installation dialog appears, click
Continue Anyway
.
3. In the Please choose your search and installations dialog, select Search for the best
driver in these locations and include this location in search
.
4. Use the Browse... button to navigate to one of the following paths:.
<ZDS II Installation Directory>\device drivers\USB\x32
<ZDS II Installation CD>\Device Drivers\USB\x32
5. Click Next to locate the appropriate driver.
6. Click
Next
, then click
Finish
to complete the installation.
Installing the FTDI USB-to-UART Driver
An FTDI USB-to-UART driver is required to allow your PC to communicate through its
USB port to the on-chip UART of the eZ80Acclaim
Plus! MCU. Observe the following
procedure to perform these connections.
1. Ensure that the USB cable is not plugged in to the eZ80Acclaim Plus! Development
Board’s P3 connector.
2. Navigate to the following filepath and double-click the CDM20802_setup.exe file to
begin the driver installation.
<CDROM>\Device Drivers\FTDI Uart
3. The installation process will begin and you should observe output similar to the fol-
lowing messages on the screen of your PC:
32-bit OS detected

<installation path>\dpinstx86.exe

Installation driver

FTDI CDM driver installation process completed...
4. When the installation is complete, plug in the Mini-B connector of the second USB
cable into the Board, and the larger A connector into the USB port of your PC.
Note: