ZGR TOWER PRO 6 10 KVA
Operation manual
www.zigor.com
31
27
Mains Site Wiring Fault
Once per second
Fault LED blinking
28
Bypass Site Wiring Fault
Once per second
Fault LED blinking
29
Output Short-circuit
Once per second
Fault LED blinking
30
Rectifier over current
Once per second
Fault LED blinking
31
Bypass over current
Once per second
BPS LED blinking
32
Overload
Once per second
INV or BPS blinking
33
No battery
Once per second
BATTERY blinking
34
Battery under voltage
Once per second
BATTERY blinking
35
Battery low pre-warning
Once per second
BATTERY blinking
36
Internal Communication Error
Once per second
Bypass LED lit
37
DC component over limit.
Once per 2 seconds
INV blinking
38
Parallel Overload
Once per 2 seconds
INV blinking
39
Mains volt. Abnormal
Once per 2 seconds
BATTERY LED lit
40
Mains freq. abnormal
Once per 2 seconds
BATTERY LED lit
41
Bypass Not Available
BPS blinking
42
Bypass unable to trace
BPS blinking
43
Inverter on invalid
44
UPS in bypass mode for a long time
45
EPO (Emergency Power Off activado)
Beep continuously
Fault LED lit
Table 4-3 Alarm information ZGR TOWER PRO 6 10 KVA
WARNING
The following process must be performed if UPS is connected with generator:
•
First turn on generator, after it runs stably connect output power of generator to UPS input terminal,
then turn on UPS. After UPS turned on, please connect load one-by-one.
•
It is recommended that the generator capacity is as twice as UPS rated capacity
