Matrix Switching System
—
User Manual
18
6.0.5.3 LAN Port
AX-88 supports a network RJ45 registered jack using 8P8C modular connector, which
specifies the physical male and female connectors as well as the pin assignments of the
wires in a telephone cable. (A common LAN cable is available.)
Figure 6-11 LAN Port
6.0.5.4 DIP Switcher 8 Pins
Figure 6-12 DIP Switchers
A. DIP Switcher
Pin
1 to 5: Switch to up (ON) is specified for
“0”, on the other hand to
down (OFF) is specified for
“1”. For Device ID settings refer to
B. DIP Switcher
Pin
6: RS-232/LAN Communication
Port Enable/Disable. Only one
matrix device can be connected to other device via RS-232/LAN that is specified as
Master, others are specified as Slave.
ON: RS-485 Serial Master and RS-232 / LAN Enable.
OFF: RS-485 Serial Slave and RS-232 / LAN Disable.
C. DIP Switcher
Pin 7: Switch between RS-232 port and LAN port connection.
ON: RS-232
OFF: LAN
D. DIP Switcher
Pin 8: Reset the web server IP address to
192.168.0.3
The steps are as below:
1. Please adjust the pin8 to OFF
and re-start AX-88.
2. After the AX-88 re-starts about 10sec, shut down your equipment.
3. For a normal operation, please adjust the pin8 to ON, then power on AX-88
again. The IP address will be restored to the default value:
192.168.0.3