ZigBee Wireless Dimmer Switch
09.ZGK2D.04837
55.57 mm
71.20 mm
11 mm
Function introduction
Important:
Read All Instructions Prior to Installation
Front side
Back side
Battery: CR2430
Before the first use, please remove the protective film
Product Data
5
5
.5
7 m
m
7
1
.2
0 m
m
The remote control can be fixed on
the wall with 3M glue or screw.
Press and hold down both keys together to search and pair
to ZigBee network or factory reset the dimmer switch.
Click to turn on the paired
lighting devices, press
and hold down to increase
light intensity
Note: This switch
supports 48 binding
tables and 2 groups for
binding lighting devices.
Click to turn off the paired
lighting devices, Press
and hold down to
decrease light intensity
Protocol
Operation Voltage
Transmission Frequency
Transmission Range (free field)
Protection Type
Dimming Range
Dimensions
ZigBee 3.0
3VDC (CR2430)
2.4GHz
30m
IP20
0.1%-100%
71.2x71.2x13.6mm
•
This device contains a button lithium battery that shall be stored and disposed properly.
•
DO NOT expose the device to moisture.
Safety & Warnings
Operation
1.This ZigBee dimmer switch is a wireless transmitter that communicates with a variety of ZigBee
compatible systems. This transmitter sends wireless radio signals that are used to remotely control a
compatible system.
2.This ZigBee dimmer switch supports 1 group for binding lighting devices and enables to control
single color ZigBee lighting devices.
3.Pair to ZigBee Lighting Device Via TouchLink without Coordinator (Hub or Controller)
1)Initiate TouchLink Commissioning of ZigBee lighting device, please consult its manual to learn how.
2)Bring the switch within 10cm of the ZigBee lighting device.
3)Press and hold down both and keys until the LED indicator on the switch turns on.
4)Click button twice continuously to start TouchLink commissioning procedure of the switch.
5)The LED indicator will first flash 6 times fast to indicate linking successfully and 4s later it will flash 4 times
slowly to indicate successful binding to the device.
Note: Each lighting device can only pair to one switch via touchlink, and can not pair to different
switches simultaneously. If TouchLink fails, please factory reset the lighting device and initiate
TouchLink Commissioning again.
4.ZigBee Network Pairing Via ZigBee Coordinator (Hub or Controller Interface)
1)Please make sure the switch does not belong to any ZigBee network before pairing, click any key if the
•
•
•
•
•
•
•
•
•
ZigBee dimmer switch based on ZigBee 3.0
Enables to pair ZigBee lighting devices via touchlink commissioning without coordinator
Supports find and bind mode to pair with ZigBee lighting devices in the same network
Supports 1 group for binding lighting devices
2.4 GHz global operation
Long battery life mesh technology
Transmission range up to 30m
Compatible with universal ZigBee Gateway products
Compatible with universal single color ZigBee lighting devices
