STW164IP
12660-0710-00
Page
14 / 30
www.ziehl.de
WARNING!
In the case of a non-loaded (open) secondary circuit of the current transformer
STWA1 (H), high voltages are induced at its secondary terminals. In case of primary
currents > 16A, the resulting voltage values are dangerous for persons.
"Open operation", i.e. operation of the current transformer without secondary wiring,
must be avoided.
When dimensioning the power supply, the power consumption of all devices must be taken into
account.
•
STW164IP
•
of the connected STW161M/STW168M
•
of the connected sensors with auxiliary voltage
•
of theconnected sliders / flaps (only if supplied via the power supply)
It must also be ensured that sufficient voltage is available at each BUS participant (STW164IP,
STW168M, STW161M and, if applicable, sliders/flaps). The cable cross-section and the line length of the
BUS cable must be taken into account. If necessary, additional power supply units can be inserted into
the BUS lines.
9
Assembly
The device can be fastened:
•
Distributor installation on 35mm mounting rail to EN 60715
•
With M4 screws for wall mounting. (additional bars not included)
•
Connect according to the connection diagram or rating plate.
10
Commissioning
10.1 Overview of commissioning
must
can
Overview
X
9.2 Switching on the device
X
9.3 Device in the network
X
9.4 Operation on the device
X
9.5 Displays on the device
X
9.6 Parameters
X
9.7 Code lock
X
9.5 Simulation
10.2 Switch on the device
Switch on the supply voltage,
>
The display turns on, after about 1s the device is ready for use
>
The device language must be specified during initial startup. Use the joystick button to navigate to the
language you want (German/English) and select.
10.3 Device on the network
If the STW164IP is connected to a network via an Ethernet, the measured value display and programming can
be performed via a web browser on the computer.
Basic knowledge of network engineering is required for configuration.
10.3.1 Find device in the network
Network with DHCP server:
After connecting to the network, the device will automatically receive an IP address.
