4. All 6 cable entry points are in a sealed condition at delivery. Remove plastic fastener depending
on the need and insert appropriate cable glands (not in scope of delivery). The manufacturer's
speci
fi
cations for tightening torque and sealing area must be observed! Entry points that are not
used must remain sealed!
5. Insert cables properly and ensure tightness of the cable glands.
6. Attach the cover of terminal compartment again carefully after connection (
Electrical Installa-
tion).
Tightening torque of the lid screws: 2 Nm
7. Install enclosed ventilation grid at the top of the unit.
4.4
Outdoor installation
Outdoor installation is possible up to -20
°
C when the controller supply is not switched off. Installation
must be protected from the effects of weather as much as possible, including protection from direct
sunlight!
4.5
Installation location for agriculture
In order to avoid damage caused by ammoniac vapours, the controller shall not be installed in the
stable, but rather in an outhouse wherever possible.
4.6
Temperature in
fl
uences during commissioning
Avoid condensation in the controller and functional faults attributable to condensation by storing the
controller at room temperature!
Operating Instructions
Fcontrol
–
model series FXDM25/32AM
Mounting
L-BAL-E212-GB 1451 Index 003
Part.-No.
12/123
