Wireless
Strobe Siren
Z.HA.HA.HOOT.ATOUCH.SIREN
User Manual
Introduction
PCB Layout
Adapter Jack
Connect to Control Panel
Press the connect button, siren beeps once and enter connection
status. Press
[Arm (?) ]
or SOS button on the panel, the wireless siren
and control panel are connected successfully after one beep is heard
from siren.
Note:
Once the siren is in connection status, please press connect button
again to exit. One beep will be heard from siren.
When connecting to control panel, please don't trigger any other sensors
to avoid interference.
Setup
Wireless strobe siren is to deter the intruders through hooting once it
receives wireless signal from connected control panel or sensors. More
wireless strobe sirens could be connected to the same control panel to
strengthen the deterring effect. When the siren is connected to control
panel as an accessory, it will hoot and its LED lights will flash once the
system is triggered. When the siren is connected to sensors like remote
control, door/window contact, and PIR motion detector, etc. as an
standalone alarm control panel, it will hoot and its LED lights flash once
any sensor is triggered.
Product Overview
Please setup alarming volume and alarming duration time on the PCB
board accordingly.
Alarming Volume and Duration Setup
Note:
When the siren is connected to control panel, it wil I hoot at the
preset volume even if the control panel is set to mute alarm. This is to alert
the neighbors and avoid the intrusion. When the control panel is set to
mute disarm/arm, the siren will be disarmed/ armed mutely. When the
siren is set to mute mode, there are still tones for arming and disarming.
Work as Wireless Siren
When it works as a wireless siren, it should be connected with wireless
control panel in advance. When the control panel is alarming, it hoots
and the strobe light flashes to deter illega intruders.
Work as Standalone Alarm Panel
When it works as a standalone alarm panel, it should be connected with
wireless sensors in advance, when the intrusion is detected, it hoots and
the strobe light flashes to deter illega intruders. Maximum 40 sensors
can be connected to the wireless strobe siren.
Connect with Remote Control
Press connect button on the siren once. A beep is heard means the siren
enters connection status.
Press any button in the remote control, the connection succeeds when a
beep is heard from siren.
Connect with Door Window Contact
Make sure the gap marks on the side of transmitter and magnet are
closed to each other and within the range of 1cm.
Press the connect button on the siren once. A beep is heard mean the
siren enters connection status. Separate the magnet from the transmitter
over 2 cm, the connection succeeds when a beep is heard from siren.
Note:
Once the tamper switch is triggered, it will alarm immediately.
Summary of Contents for Z.HA.HA.HOOT.ATOUCH.SIREN
Page 3: ......
