Zhone IMACS 8000, User Manual

Page: 586 / 788

21-28 Server Cards
Model No.
Running Head
IPR*4PPP Configuration Screens and Settings IPR*4 Router Card
release in use, some of the field actions (such as State, Interface name and/or Default gateway)
will update all four jacks. The system will prompt to apply the change to all the affected jacks
when the change taking place affects all four jacks.
Figure 21-17.Ethernet screen for IPR*4 card
The IPR*4 card uses ethernet jack 1 as the base address for the router card. The first ethernet
jack interface must have an IP address assigned to it, and be active. Changing the status of
the first ethernet jack will result in a card restart. This restart is required to allow for proper
handling of messages to and from the card. The system will prompt when placing the first
ethernet jack into a standby or active status that the card will perform a restart. This restart is
executed automatically by the system once the jack is made active, and the change is saved.
The other three jacks - numbered 2 through 4 - do not have this constraint, and can be removed
and placed back in service without the need to reset the entire card.
Table 21-6. IPR*4 10/100BT Ethernet Menu Option Settings and Defaults
Parameter User Options Default
STATE actv stdby stdby
DEFAULT GATEWAY IP address - 0.0.0.0 0.0.0.0
INTERFACE NAME user selectable none
SPEED 10 100 auto auto
DUPLEX half full half
IP MTU 1500 1500
RIP Rx off on on
RIP Tx off v1 v2 v2
SH yes no yes