5
Charging Procedure
1. Insert the batteries into the charger in the right direction (positive/negative end)
accordingly.
2. Connect the charger to the adapter via the Micro USB cable.
3. Plug the adapter into a power outlet to start charging.
Micro USB Cable
Micro USB Cable
Adapter
Adapter
Power Outlet
Power Outlet
1. Micro USB 5V charging ports are on both sides of the charger. Users
are free to charge battery from one side of the charger or both of them.
Charging from both of the charging ports will take less time.
2. Charging the batteries may fail when the power supply is insufficient (for in-
stance, when the current of the adapter is lower than 1000mA). Conditions
may vary depending on the specific chargers used. It is recommended to
use an adapter with higher current capacity;
3. The battery cannot be charged through the USB port on the stabilizer.
1.
Please use qualified standard 5V/≥2000mA adapter for battery charging;
charging time depends on the maximum input current of the adapter.
2. This stabilizer comes standard with dedicated high-discharge-rate batteries.
Please use batteries provided or approved by ZHIYUN only.
3. Please make sure the batteries are fully charged. Undercharged battery or
batteries can lead to the failure of the stabilizer.
Charging Procedure
Summary of Contents for Crane 3 Lab
Page 2: ...Z H I Y U N E N v 2 1 0 CRANE 3 LAB User Guide ...
Page 37: ......