ZF CruiseCommand 785CE, Installation And Troubleshooting Manual

Page: 46 / 160

SET-UP PROCEDURES
Page 38
B) Use the Up or Down arrow to scroll to the C1 Function Code.
C) Activate Set-up Mode. Refer to Section 6.2.
D) Change the Value of the Function.
E) When the value required is displayed, store the value. Refer to
Section 6.2.
6.3.14C2 - Reversal Pause
When doing a reversal in the vessels direction, a pause is introduced into
the clutch command signal to allow time for the engines RPM’s to drop to
Idle and for the vessel’s speed through the water to slow. Whether this
pause occurs while the clutch is engaged or at Neutral is selectable with
this function.
The values of this Function are 00 In-Gear (Default) and 01 Neutral.
To change the value:
A) Depress either the Up or Down Arrow to activate the Function
Menu.
B) Use the Up or Down arrow to scroll to the C2 Function Code.
C) Activate Set-up Mode. Refer to Section 6.2.
D) Change the Value of the Function.
E) When the value required is displayed, store the value. Refer to
Section 6.2.
6.3.15C3 Reversal Pause Time
The Reversal Pause Time feature provides engine deceleration, followed
by a pause in throttling to the commanded speed in the new desired direc-
tion, upon a Full-Speed Reversal. This pause time is proportional to how
much throttle is being commanded and for how long. In order to build up
to the pause value set, the vessel must be at full throttle and Ahead six
times the pause set. The default pause from Astern to Ahead is 1/2 the
Reversal Pause value set.
Figure 41: C1 - Clutch Oil Interlock Delay Set-up Activated
Figure 42: C2 - Reversal Pause Set-up Activated
Function Code is blinking