ZF CruiseCommand 785CE, Installation And Troubleshooting Manual

Page: 44 / 160

SET-UP PROCEDURES
Page 36
D) Change the Value of the Function.
E) When the value required is displayed, store the value. Refer to Sec-
tion 6.2.
6.3.10E6 - High Idle
This Function is accomplished during Adjustments.
6.3.11 E7 - Active Synchronization
The Systems default method of synchronization is an Equal Throttle Syn-
chronization. With this type of synchronization the Processors ensure that
the same or an equal Throttle Command Signals are applied to both Gov-
ernors when the synchronization criteria has been met. Though not true
Synchronization, in most cases synchronizing in this manner is very effec-
tive.
If a true synchronization is required or requested, Active Synchronization
would need to be selected. In addition, Active Synchronization requires a
Tachometer Signal representative of each engines’ RPM’s. The frequency
of these signals are measured and changes to the Throttle Command Sig-
nal outputs of the Processors are made until the frequency of both engines
are the same and both engines are running at the same RPM.
The values of this Function are 01 Enabled and 00 Disabled (Default).
To change the value:
A) Depress either the Up or Down Arrow to activate the Function
Menu.
B) Use the Up or Down arrow to scroll to the E7 Function Code.
C) Activate Set-up Mode. Refer to Section 6.2.
D) Change the Value of the Function.
E) When the value required is displayed, store the value. Refer to Sec-
tion 6.2.
Figure 38: E5 - Throttle Pause Set-up Activated
Figure 39: E7 - Active Synchronization Set-up Activated
Function Code is blinking