ZF CruiseCommand 785CE, Installation And Troubleshooting Manual

Page: 43 / 160

SET-UP PROCEDURES
Page 35
To change the value:
A) Depress either the Up or Down Arrow to activate the Function
Menu.
B) Use the Up or Down arrow to scroll to the E0 Function Code.
C) Activate Set-up Mode. Refer to Section 6.2.
D) Change the Value of the Function.
E) When the value required is displayed, store value. Refer to Section
6.2.
6.3.5 E1 - Throttle in Neutral
This Function is accomplished during Adjustments.
6.3.6 E2 - Throttle Minimum
This Function is accomplished during Adjustments.
6.3.7 E3 - Throttle Maximum
This Function is accomplished during Adjustments.
6.3.8 E4 - Throttle Maximum Astern
This Function is accomplished during Adjustments.
6.3.9 E5 - Throttle Pause Following Shift
This value determines the amount of pause from the point where the
clutch engagement signal is given, to the point where throttle is allowed to
increase above Idle.
The values of this Function are 00.0 to 02.5 seconds.
Default Value is set to 00.5 second pause.
To change the value:
A) Depress either the Up or Down Arrow to activate the Function
Menu.
B) Use the Up or Down arrow to scroll to the E5 Function Code.
C) Activate Set-up Mode. Refer to Section 6.2.
Figure 37: E0 - Select Engine Set-up Activated