![background image](http://html.mh-extra.com/html/zf/av-110/av-110_repair-instructions_932414083.webp)
Checking axial run-out.
12. Place dial gauge to the crown wheel rear
side.
13. Turn input flange and check Axial run-out
crown wheel max. 0.08 mm.
If the permitted axial run-out is not
observed, check and correct contact of
the crown wheel.
Fig. 146
Setting rolling torque differential bearing and checking contact pattern.
14. Measure distance from the front face of the
AA02.060.628 [Test device] to the front face
of the bearing inner ring. Measure distance of
each hole and calculate average.
Distance A = e. g. 59.44 mm
Fig. 147
15. Remove AA02.060.628 [Test device].
16. Use AA01.266.870 [Load-lifting equipment]
to remove the differential from the axle
housing.
17. Check contact pattern
(See Check contact
pattern)
.
Correct deviations from the contact
pattern.
If the shim for the contact pattern is
changed, proceed as follows:
▪ Adapt ring for the rolling torque
Fig. 148
Assembly
EN 4472.751.001 - 2015-11
83
Summary of Contents for AV 110
Page 1: ...REPAIR INSTRUCTIONS AV 133 Bus axle with compact bearing BUSES ...
Page 137: ......