![background image](http://html.mh-extra.com/html/zf/av-110/av-110_repair-instructions_932414082.webp)
5.
Slide bearing inner ring (1) onto
AA02.060.628 [Test device].
Fig. 143
6.
Put AA02.060.628 [Test device] onto the axle
housing.
7.
Install AA02.060.628 [Test device] evenly
with cylindrical screws until contact is
obtained.
8.
Tighten cylindrical screws crosswise.
Tightening torque: 185 Nm
9.
Turn pinion:
▪
Speed: 50 1/min
▪
Duration (always left and right): 15 s
Fig. 144
10. Place dial gauge at right-angled surface of a
hexagon screw at the differential.
11. Backlash bevel gear set
e. g. 0.22 mm (±0.04 mm) Check
(see
Reassemble differential)
.
If the required backlash is not reached,
replace the disk as specified below:
▪ In case of an insufficient backlash,
install a thicker shim.
▪ In case of an excessive backlash,
install a thinner disk.
Fig. 145
Assembly
82
EN 4472.751.001 - 2015-11
Summary of Contents for AV 110
Page 1: ...REPAIR INSTRUCTIONS AV 133 Bus axle with compact bearing BUSES ...
Page 137: ......