![background image](http://html.mh-extra.com/html/zf/av-110/av-110_repair-instructions_932414078.webp)
20.
Risk of burn injuries due to contact with hot
surfaces.
Slight or moderate injury possible.
ð
Wear protective gloves.
Heat input flange.
21. Slide input flange onto the pinion until
contact is obtained.
Fig. 133
22. Use AA02.016.086 [Plug insert],
AA00.640.418 [Support fixture] and
5870.203.002 [Power screwdriver] to tighten
the double hexagon nut removed during
disassembly.
Tightening torque: 1,000 Nm
Fig. 134
23. Rotate pinion several times in both directions.
24. Check the necessary pinion bearing rolling
torque 4 Nm – 10 Nm.
25. If the rolling torque is too small, retighten the
double hexagon nut, until the necessary
rolling torque is reached.
Tightening torque: 1,000 Nm – 1,700 Nm
▪ In case of an insufficient rolling
torque, install a thinner ring.
▪ In case of an excessive rolling torque,
install a thicker ring.
26. Note down the applied tightening torque and
adjusted rolling torque.
Fig. 135
Assembly
78
EN 4472.751.001 - 2015-11
Summary of Contents for AV 110
Page 1: ...REPAIR INSTRUCTIONS AV 133 Bus axle with compact bearing BUSES ...
Page 137: ......