2
Safety Instructions
2.1
General safety instructions
Please read all safety instructions. Failure to comply with safety information and instructions may lead to
property damage, serious injuries, or death.
Intended use
The ZF product is exclusively intended for the application as defined in the contract and as agreed on
delivery. Any other or extended form of use does not comply with this definition of intended use. The
intended use includes compliance with this documentation and other applicable documents, in order to
avoid malfunctions and damage in operation.
The ZF product is designed and produced in line with state-of-the-art technology and is safe to operate.
However, this ZF product may pose dangers if improperly used by unauthorized, untrained, and
uninstructed specialized staff or if not used according to its intended use.
Repair, assembly, maintenance, and commissioning
Perform repair, assembly, and maintenance work exclusively according to this documentation on hand and
other applicable documents paying particular attention to the points mentioned below:
▪ Work must be performed in a professional manner and according to the technical provisions.
▪ Work must only be performed by trained, instructed, and authorized specialized staff.
▪ Only original ZF spare parts may be used.
▪ Only original ZF accessories may be used.
▪ Only original ZF special tools may be used.
▪ Changes and modifications of the ZF product may lead to the expiry of the operator's license, warranty,
or guarantee.
In case of damage, immediate action is mandatory in order to restore or guarantee full functionality and
safety / operational safety of the ZF product and to minimize the extent of damage.
In case of damage, contact ZF Services and have the following information ready:
▪ Product type, product parts list number, and serial number
▪ Total mileage [km]
▪ Progress of the damage
▪ Damage pattern
To avoid personal injury and damage to third-party products and the ZF product, this safety information,
all valid safety regulations, and legal requirements must be observed.
Country-specific safety, accident prevention, and environmental regulations apply irrespective of the
information provided in this document.
Safety-relevant workwear must be worn for all work. Depending on the type of work, additional protective
equipment, e.g. protective goggles, protective gloves, hard hat, and apron must be used. The workwear
must fit tightly so that it cannot get caught in turning or protruding parts.
Safety Instructions
6
EN 4472.751.001 - 2015-11
Summary of Contents for AV 110
Page 1: ...REPAIR INSTRUCTIONS AV 133 Bus axle with compact bearing BUSES ...
Page 137: ......
