1.
Bolt in two pieces AA00.844.345 [Load ring]
(1) onto the portal housing.
2.
Grease the O‑ring (2) and insert it into the
annular groove on the portal housing.
3.
Push the stub shaft with the pin showing
inwards into the drive gear of the portal drive.
Thereby take up the shaft washer with the
pin on the drive gear.
4.
Push the stub shaft into the axle housing and
bring the portal housing into contact position
with the axle housing.
Fig. 237
5.
Support axle from below (1).
6.
Fix portal drive with Torx screws.
Tightening torque: 185 Nm
Fig. 238
9.7
Install breather neck
1.
Push the breather neck into the hole on the
axle housing so that an edge of the hexagon
is parallel to the portal housing.
2.
Risk of injury due to parts flying away.
Slight or moderate injury possible.
ð
Wear protective goggles.
Force the breather neck with a sleeve or a
tube into the axle housing.
Fig. 239
Assembly
EN 4472.751.001 - 2015-11
117
Summary of Contents for AV 110
Page 1: ...REPAIR INSTRUCTIONS AV 133 Bus axle with compact bearing BUSES ...
Page 137: ......
