ZF Marine ClearCommand, Manual, Page: 94 / 104

TROUBLESHOOTING
Page 8
B) Install a jumper between the appropriate terminals of the Pro-
cessor. Refer to the main manual for appropriate terminals.
1.14SYMPTOM - C
ANNOT GET ANY SPEED ABOVE
IDLE.
Cause :
A)Gear oil pressure switch is not closing, or is incorrectly wired.
B) The gear oil pressure switch not installed.
Remedy :
A)Replace the pressure switch or correct wiring.
B) Install a jumper between the appropriate terminals of the Auxil-
iary Circuit. Refer to the main manual for appropriate termi-
nals.
1.15SYMPTOM - A
SLOW REPETITIVE TONE IS HEARD FROM ALL
S
TATIONS WHEN POWER IS APPLIED TO THE SYSTEM
. T
HE SLOW
REPETITIVE TONE CEASES WHEN THE TRANSFER BUTTON IS
DEPRESSED
. S
UBSEQUENTLY
,
A STEADY TONE IS HEARD WHENEVER
THE TRANSFER BUTTON IS DEPRESSED
. T
HE
C
ONTROL
H
EAD
LED
DOES NOT LIGHT
. T
HE TRANSMISSION AND ENGINE REMAIN AT THE
N
EUTRAL
/I
DLE POSITION REGARDLESS OF
C
ONTROL
H
EAD LEVER
POSITION
.
Cause :
The Processor is in the Set-up Mode.
Remedy :
Configure the Processor into the Run State by placing Jumper 2 in the
Open State . Refer to the Run State Section of the manual.
1.16SYMPTOM - A
SLOW REPETITIVE TONE IS HEARD FROM ALL
S
TATIONS WHEN POWER IS APPLIED TO THE SYSTEM
. W
HEN THE
TRANSFER BUTTON IS DEPRESSED
,
THE TONE CEASES BUT THE RED
LED
DOES NOT LIGHT
. F
URTHER DEPRESSING OF THE TRANSFER
BUTTON HAS NO EFFECT
. T
HE TRANSMISSION AND ENGINE REMAIN