ZF Marine ClearCommand 9000 Series, Installation, Operation And Troubleshooting Manual

Page: 77 / 272

SET UP
Page5-1
5 SET UP PROCEDURE
The Processor utilizes push buttons in conjunction with Display
LED’s to program, adjust, calibrate and set up the various features.
The push buttons also allow you to access and display information
regarding the health of the System. The following paragraphs
explain how to locate and use the push buttons and Display LEDs:
5-1 P
ROCESSOR
C
OMPONENTS
U
SED
I
N
S
ET
U
P
Figure 5-1: Typical Processor Cover
• Each Processor has a Display
LED and Push Buttons.
• The Display LED can be viewed
through a window on the Pro-
cessor’s cover as shown in Fig-
ure 5-1:
Figure 5-2: Processor Shield Push Button and Display LED
Locations
• The Processor enclosure cover
must be removed to access the
Push Buttons as shown in Figure
5-2:
• The
Display LED is used to view
the Function Codes and the Val-
ues for those Functions (Section
5-1.1, page 5-2).
• The Push Buttons are used to
scroll through Function Codes,
select Function Codes and set the
Values of the Function Codes.
(Section 5-1.2, page 5-2)
LED Display
Window
12268
Push Button Location
12255
LED Location