ZF Marine ClearCommand 9000 Series, Installation, Operation And Troubleshooting Manual

Page: 101 / 272

SET UP
Page5-25
5-6.5.2.2 Function Code
L2
– Troll Minimum Pressure
This Function adjusts the Troll Push-Pull cable travel
to the point where clutch pressure is at the minimum
point where shaft rotations are still possible.
The hydraulic pressure on the Clutch plate can typi-
cally be decrease to a point where the shaft is rotat-
ing at 30% to 50% of normal shaft RPM at Idle.
The available Values are
0.10
to
80.0
percent of the
3.00 inches (76,2mm) of Troll Push-Pull cable travel.
The Default Value is
70.0
%.
The Value selected must always be at least 10% below
the Troll Maximum Pressure
L3
selected.
To determine, and if required, change the Value
(Refer to Sections 5-2 and 5-3, page 5-5):
5-6.5.2.3 Function Code
L3
– Troll Maximum Pressure
This Function adjusts the Troll Push-Pull cable travel
to the point where clutch pressure is at the maximum
point, yet not quite at normal shaft RPM at Idle.
The hydraulic pressure on the Clutch plate can typi-
cally be decreased to a point where the shaft is rotat-
ing at approximately 70% of normal shaft RPM at
Idle.
The available Values are
20.0
to
100.0
percent of the
3.00 inches (76,2mm) of Troll Push-Pull cable travel.
The Default Value is
90.0
%.
The Value selected must be at least 10% above the
Troll Minimum Pressure
L2
selected.
NOTE: R
EFER TO THE FOLLOWING
S
ECTIONS WHEN MAKING THE
T
ROLL
M
INIMUM AND
T
ROLL
M
AXI
-
MUM
P
RESSURE ADJUSTMENTS
. A S
HAFT
T
ACH IS REQUIRED TO PROPERLY ADJUST THESE
ITEMS
. T
HESE ADJUSTMENTS ARE BEST DONE WHILE UNDERWAY
.
Figure 5-51: Display LED
Function L2 Set Up Activated
A) Move the Control Head lever to the Ahead
detent.
B) Scroll to Function Code
L2
.
C) Activate Set Up Mode.
D) Scroll Up or Down to the desired Value
E) Store the Value to memory
Figure 5-52: Display LED
Function L3 Set Up Activated
To determine, and if required, change the Value
(Refer to Sections 5-2 and 5-3, page 5-5):
A)Move the Control Head lever to the Ahead
detent.
B) Scroll to Function Code
L3
.
C) Activate Set Up Mode.
D) Scroll Up or Down to the desired Value
E) Store the Value to memory