ZETRON 4000 Series, Installation Manual

Page: 60 / 418

Common Control Equipment Installation
60 025-9533Y
5. Press E to define the desired Emergency ANI behavior from the following menu:
All,Only_1st,Timed,<BS> :
6. If you choose the timed option, select the timer duration.
60sec,30sec,15sec,5sec,<BS>
7. Backspace to the GE-Star menu.
8. Press
M
to enable or disable muting
Enable,Disable<BS> :
SS1 Selective Signaling Decoding

To set SS1 options
1. Press S to enable SS1 ANI decoding.
1digit,2digit,3digit,<BS>
2. Select 1-digit, 2-digit, or 3-digit decoding.
Transmit Delay
Transmit delay is a fixed audio delay that may be programmed for each channel. It is
programmable in 0.25-second increments from none to 3.75 seconds. Transmit audio is
buffered for the programmed interval then sent to the channel. This allows the operator to
begin speaking immediately upon keyup without regard of any delays imposed by the
radio network.

To select the transmit delay for the current channel
1. Press D. The following menu appears:
delay(sec.)= A:none, B:0.25-2.0,
C:2.25-3.75, <BS> :
2. Select A, B, or C, depending on the range of delay desired.
3. Select the final value from the options presented.
Option Result
A All emergency ANI numbers are reported
O Only the first occurrence of an emergency ANI number is
reported. Subsequent repeats are ignored until a different ANI
number is received.
T A timer starts when an emergency ANI number is received.
Repeats of that number are ignored for the duration of the
timer. Any other emergency ANI number is reported and
restarts the timer.
Note
The muting option is only functional if the SIMM option is installed.