ZETRON 4000 Series, Installation Manual

Page: 56 / 418

Common Control Equipment Installation
56 025-9533Y
Channel Configuration

To configure the operating mode of each channel
1. From the main menu, press C.
2. Press A or B to configure Channel A or Channel B. The following menu is
displayed:
Define,Review,Store,Init,Log, <BS> :
• Pressing ‘R’ displays the new configuration.
• Pressing ‘I’ resets the new configuration to the current configuration.
• Pressing ‘S’ makes the new configuration permanent and resets the card.
• Pressing ‘L’ displays a logging submenu:
Ani,Call,<BS> : C
• Pressing ‘A’ displays the option to log ANIs from this channel.
• Pressing ‘C’ displays the option to log calls from this channel.
3. Press D to define a new configuration. The following menu appears:
Type,Call,agcPeak,Ani,txDly,<BS> :
Type

To assign a channel type
1. Press T. The following menu appears:
Dc,Tone-std,tone-Custom,Local,<BS> :
2. If this is a Tone/Local DCC, press T, C, or L to select this channel’s control type.
Do not choose option D, which is intended only for certain legacy cards.
If ‘Tone-std’ is selected, a standard tone channel is configured with these default
characteristics:
* With a 2175 Hz Guard Tone, there is a notch filter from 2120 Hz to 2230 Hz.
3. To change these default values, select tone-Custom. The following menu is
displayed:
gtFreq,hlgtDur,llgtLevel,disable_loTl,
disableRemote,disableGt_dly,<BS> :
Note
A new configuration will have no effect on the channel until it is
stored by this command.
Guard Tone 2175 Hz*
High-Level GT duration when ‘OPT’ switch is ON 600 ms
Low-Level GT amplitude -30 dB
LOTL Enabled
Remote Function Enabled
GT/Remote voice delay Enabled