ZETRON 4000 Sereis, Manual

Page: 109 / 160

109
Operation
Figure 32: SDC Status Select Subwindow
Ending a Call
The END CALL button terminates an SDC private call or removes the radio from an SDC
group call.
Resetting the Radio
If the radio supports the reset function, it can be reset from the IntegratorRD Misc menu
by clicking SDC RESET. Pressing this button commands the radio to perform a full reset
of the radio as if the radio had been powered up. The reset process takes about 20 seconds
to complete, during which time the radio can not send or receive calls.
MAP27 Functions
Incorporation of MAP27 interface support into the IntegratorRD adds a MAP27 Call
submenu, and the option of adding MAP27 specific buttons to the main screen, so the user
can make calls on each MAP27 radio. A Call Window can be enabled, which has two
subwindows. The first tab displays the Call History window to show a list of received
status codes, call alerts, and private calls. The second tab displays the Subscriber List
window to show the subscriber ID. It is equipped with MAP27 specific buttons so that
calls can be made from this window.
MAP27 Call Submenu
A MAP27 Call submenu is available with the submenu buttons on the right hand side of
the main screen. This submenu replaces the bottom two rows of the IntegratorRD buttons
with a list of the programmed MAP27 subscribers and all the MAP27 specific control
buttons while active.
If the configuration is programmed for multiple groups of MAP27 radios (up to 10
groups), a screen similar to
Figure 33 is displayed. Selecting one of these group buttons
displays a set of related MAP27 Subscriber IDs as shown in Figure 34 . If more than 10
IDs are programmed for the group selected, the IDs can be navigated using the “Next”
and/or “Prev” buttons. At any point the “Back (Grps)” button returns the user to the main
screen showing the Radio groups.
Note Not all SDC radios support this function.