ZEROXCLUB Instructions Manual
2
2. Installation
2.1 Installation Safety Precautions
Ensure the power supply circuit has circuit protection
Connect the rear camera to a 12-14V DC circuit only
Use insulated tools when working with power supply
Use correct safety equipment when working at elevated
levels
Ensure correct polarity of 12V DC power supply to the
camera. Red = Positive.Black=Negative.
Do not allow water to enter the LCD Display.
Excessive heat can be caused by a loose connection.
2.2 Wiring
Installation is relatively quick and easy provided you know a little
about cars and power tools.
Basic knowledge on the workings of your car and the operation of
a drill is all you need to install a backup camera on the your vehicle.
You need to plan properly ahead, in order to allow the wire to pass
through you need to depend on where you decide to install the
camera and the monitor to drill holes through the car’s body.
You will find a video wire with a 6 colors wire from your monitor,
connect those to the fuse box.
There's a red cable for ACC, yellow for 12V+, black for ground,
green for the parking lines and the blue/grey for backup. If the
parking lines wire is used (optional), when it goes to 12V+, the
system will automatically switch to #2 and display the backup
parking lines. This is so you use camera #2 for the backup and
#1/3/4 for anything else. Below is a wiring diagram.
