ZEROXCLUB Instructions Manual
7
The camera base detaches by removing the four housing
screws using a miniature Phillips screwdriver. The base can
then be screwed or bolted onto in the desired location. A short
4-pin aviation camera is attached to the camera. And you also
can adjust the lens during this step.
Remove the screws
of the camera
Open the housing of
the camera to reveal
the dome camera
and the base. Fix the
base in the car
where it needs to be
mounted
Rotate the dome
camera to get the
angle and image you
want, then put the
housing in place and
tighten the screws.
2.4.3 Adjust the Camera View
●
You can use the camera mount to mark where to drill holes
which is wide enough for the 4 pin connector.
●
Adjust the camera to the correct angle as needed. The camera
should be adjusted to a horizontal position relative to the ground in
order to provide the best view of the objects behind the vehicle.
●
When the preferred view for each camera is obtained, tighten the
screws to prevent the camera angle from deviating due to vibration
during driving.
