Zero SR/S, Service Manual

Page: 20 / 290

10-10 Motor Commissioning
Maintenance and Safety 10
Motor Commissioning
Motor Commissioning
Items Required:
•
Laptop (with ZDU software)
•
CAN cable
•
Black key
Important Commissioning Tasks:
•
WARNING! The motorcycle must be on a
motorcycle stand with the rear tire raised off
the ground and you must stand clear of the
rear tire, rear wheel, and drive belt, because
the rear will automatically start to rotate at a
high rate of speed during the motor
commissioning process!
•
Raise rear tire off the ground by using a
motorcycle stand.
•
Perform commissioning within 30 seconds of
key turned to the ON position.
•
“Run Mode” is kickstand up and kill switch in
run position.
•
Green Check Engine Light on the dash must
be illuminated during the process.
Procedure
1. Use a motorcycle stand to raise the rear tire off
the ground.
WARNING! The motorcycle must be on a
motorcycle stand with the rear tire raised off
the ground and you must stand clear of the
rear tire, rear wheel, and drive belt, because
the rear will automatically start to rotate at a
high rate of speed during the motor
commissioning process!
2. Connect a laptop (with ZDU software loaded)
to the motorcycle’s OBDII diagnostic
connector with CAN cable.
3. Begin with the key to the OFF position.
4. Open the ZDU program.
5. Click on the “Motor Controller Interface” tab.