Zero UAV (Beijing) Intelligent Technology Co., Ltd. 77
NOTE：
The parachute will only open automatically, manual deployment is not supported.
The parachute will not open in circumstances such as interference, rudder vibration, or insufficient power supply and so
on.
6.2.5
Landing Gear
Landing gear wiring
NOTE
：The signal of retractable landing gear connect to the empty channel of gimabl receiver, it can also connect to the
empty channel in copter receiver.
Connecting and setting up retractable landing gear can be carried out as follows
1.
The signal wire of left and right retractable landing gear(brown,red yellow wire) plugs in left and right side of copter
bracket convert port separately.
2.
switch wire(black, red, white wire) is plugged into an empty channel of gimbal receiver as shown in figure(it can be
plugged into an empty channel of copter receiver, too).
3.
Set corresponding channel to two-switch or knob switch in the gimbal remote controller.
