Zero UAV (Beijing) Intelligent Technology Co., Ltd. 17
3.4
Setting up the Remote control transmitter (taking FUTABA remote controller for example)
Your RC transmitter (TX) must use “fixed-wing mode”, do not set up any mixes. If using a Futaba TX, none of the channels
should be reversed (
except the channel of retractable landing gear
). JR, Tiandifei and possibly other remote controls should
have all channels reversed. Video refer to: http://www.tudou.com/programs/view/e1ai526Mbt4/
When operating single remote controller or double remote controller, the remote controller which control the retractable
landing gear need to be set as following:
1.
wire connection,
control line on the retractable landing gear(label with
landing gear
) need to be connected to correspond
channel on the receiver.
2. Side lay HighOne-Pro or support it by frame, hand the landing gear in the air.
3. Open the remote controller,
do the reverse setting first
: LNK→REVERSE→ set corresponding channel to REV, after reverse
setting, landing gear get down when at position 1; it’s flying status when in position 2.
4. Then
set the stroke:
LNK→END POINT， set the two middle line of landing gear channel to 120(CH9 as an example in the
following picture)
