Zero DSR 2018, Owner'S Manual

Page: 90 / 162

General Maintenance
6.16
Wheels And Tires
Inspect both wheels for the following:

Bent or cracked rims.

Impact marks on the rims.
Inspect both tires for the following:

Cuts, cracks, splits, or missing tread lugs in the tread or
sidewall area.

Bumps or bulges within the tire body.

Uneven tire tread wear. Wear on one side of the tire
tread or flat spots in the tire tread indicate a problem
with the tire or motorcycle.

Exposed tire thread or cords.
If either of the wheels or tires are found to have any of the
above conditions, replace the wheel and tire immediately.
Tire Inflation
WARNING! Under-inflation is a common cause of tire
failure and may result in severe tire cracking, tread
separation, “blowout,” or unexpected loss of motorcycle
control, causing serious injury or death.
Tire pressure should be checked and adjusted to the
proper inflation levels before each ride. Tire pressure
should be checked using an accurate gauge when the tires
are cold. This means that the tires have not been ridden on
for at least 3 hours. Always replace the valve stem cap
when finished adjusting tire pressures.
MODEL FRONT REAR
S & SR 221 kPa (32 PSI) 234 kPa (34 PSI)
DS & DSR 221 kPa (32 PSI) 234 kPa (34 PSI)
Zero Owner's Manual (S and DS).book Page 16 Wednesday, February 28, 2018 11:21 AM