8 • Installation & Operation
INSTALLATION & OpERATION
Lineup assembly
Zero Zone display cases have been designed for continuous display so that multiple cases may be joined together to create a lineup of any
desired length. The lineup will be ready for assembly after removing the packaging material.
a case lineup must be properly aligned, which starts with properly leveling the case (
). It is crucial to use a laser
level to measure the high points in the floor and properly shim each base location.
The bottom of the end panels are protected by steel support plates, which must be unbolted and removed before the lineup is set. There are
bolts that go up through the support plates into the underside of the foamed floor.
a case must be prepared with Butyl caulk before setting the next case in the lineup. Case caulking instructions and caulk are shipped with every
case (
Move the next case into position and bolt it to the first case using the joining bolts that are provided. Begin tightening the bolts at the top rear,
working down the back of the case and up the front, making sure that the seams are flush.
Do not pull cases together using joining bolts.
). Do
not allow Butyl caulk and NSF-approved sealant to contact one another as this may affect adhesion or color of each.
FIGURE 7: Case Squareness
1. Measure squareness from top right corner of the case to the bottom left
corner of the case.
2. Measure again from the top left corner of the case to the bottom right
corner of the case.
3. Measurements should be equal. Difference should be no more than 1/8".