Zero Motorcycles ZERO FX 2016, Owner'S Manual

Page: 95 / 144

General Maintenance
6.27
Fuses
Whenever there is an excessive amount of current flowing
through a circuit the fusible element will melt and create an
open or incomplete circuit. Fuses are a one-time protection
device and must be replaced each time the circuit is
overloaded. Replace the fuse with one of equal current
and voltage rating. If the fuse melts repeatedly, have the
electrical system inspected by your dealer.
12 Volt Fuse Center
The 12 volt fuse center is located on the frame above the
front power pack.
The fuse center has a protective cover that must first be
removed to gain access to the fuses. To remove the cover,
squeeze the tabs (A) together and lift off the cover.
The 12 volt fuse values are listed below:
FUSE RATING CIRCUITS CONTROLLED
1 5A ABS 4, Key
2 10A ABS 9, Valve
3 10A Headlight
4 10A Accessory Port
5 10A Flash Lights, Turn Signals, Horn, Brake/Tail Light
6 5A Dash, Running Lights
Zero Owner's Manual (FX and FXS).book Page 27 Monday, December 14, 2015 3:02 PM