Zenoah EBZ8560, Operator'S Manual, Page: 8 / 68

• Do not smoke near the fuel or the engine.
• Do not put warm objects near the fuel or the
engine.
• Do not add the fuel when the engine is on.
• Make sure that the engine is cool before you
refuel.
• Before you refuel, open the fuel tank cap slowly
and release the pressure carefully.
• Make sure there are sufficient airflow when
refueling and mixing fuel (petrol and two-stroke
oil) or draining the fuel tank.
• Fuel and fuel vapor are highly flammable and
can cause serious injury when inhaled or allowed
to come into contact with the skin. For this
reason, observe caution when handling fuel and
make sure there is sufficient airflow.
• Tighten the fuel tank cap carefully or a fire can
occur.
• Move the product at a minimum of 3 m (10 ft)
from the position where you filled the tank before
a start.
• Do not put too much fuel in the fuel tank.
• Make sure that a leak cannot occur when you
move the product or fuel container.
• Do not put the product or a fuel container where
there is an open flame, spark or pilot light. Make
sure that the storage area does not contain an
open flame.
• Only use approved containers when you move
the fuel or put the fuel into storage.
• Empty the fuel tank before long-term storage.
Obey the local law on where to dispose fuel.
• Clean the product before long-term storage.
• Remove the spark plug cap before you put the
product into storage to make sure that the engine
does not start accidentally.
Safety instructions for maintenance
WARNING:
Read the warning
instructions that follow before you use
the product.
• Your warranty may not cover damage or liability
caused by the use of non-authorized accessories
or replacement parts.
• The inside of the muffler contains chemicals that
may be carcinogenic. Avoid contact with these
elements in the event of a damaged muffler.
• Stop the engine before assembling or
dismantling accessories or other parts.
• Check that the thick round pin (A) is inserted in
the strap. If it is inserted incorrectly it may lead to
personal injury.
A
Assembly
Introduction
WARNING:
Read and understand
the safety chapter before you assemble
the product.
To assemble the tube and handle on
the product (EBZ8560RH)
1. Attach the flexible hose (A) to the pipe angle and
the control pipe (B) with the clamps (C), (D).
B
D A
C
Note:
Lubricate the control pipe and the
flexible hose to make them more easy to
assemble.
2. Attach the handle (E) to the control pipe and put
the knob through the handle.
E
3. Tighten the knob.
8 2142 - 005 - 06.07.2023