Zenoah EBZ8560, Operator'S Manual, Page: 12 / 68

To start the product
1. If the engine is cold, push the choke lever to the
closed choke position.
2. Push the air purge bulb again and again until fuel
starts to fill the air purge bulb. It is not necessary
to fill the air purge bulb fully.
3. Push the throttle lever to the 1/3 speed
position. Refer to To operate the throttle switch
(EBZ8560RH) on page 11 or To operate the
throttle switch (EBZ8560) on page 11.
4. Put the product on a flat surface on the ground.
5. Hold the product with the left hand.
6. Pull the starter rope handle slowly until
resistance occurs.
7. Pull the starter rope handle quickly with the right
hand until the engine starts or attempts to start,
maximum 10 times. If the engine starts, move the
choke lever gradually to the open position.
Note:
Do not pull the starter rope handle to full
extension and do not let go of the starter rope
handle.
8. Move the choke lever to the open choke position
until the choke lever stops.
9. Pull the starter rope handle repeatedly until the
engine starts and continues to run.
10. If the engine does not start, do step 1 to step 10
again.
11. Let the engine run for 2-3 minutes to become
warm before operation.
To stop the product (EBZ8560RH)
CAUTION:
Do not stop the product
at full speed.
1. Push the throttle lever to the stop position.
To stop the product (EBZ8560)
CAUTION:
Do not stop the product
at full speed.
1. Push the stop switch.
Maintenance
Introduction
WARNING:
Read and understand
the safety chapter before you do
maintenance on the product.
12 2142 - 005 - 06.07.2023