ZoningBOX 6 / ZoningBOX 4
Technical Support:
7
2
CONFIGURATION
2.1
GENERAL
After importing the corresponding database in ETS and adding the device into the
topology of the desired project, the configuration process begins by entering the
Parameters tab of the device.
Important
:
The subsequent sections of this document usually refer to the output
channels as grilles, although up to two grilles can be connected to the same
output channel as long as they are the same model. In such case, for
practical purposes please consider them as a sole grille
.
This document and its figures are generally referred to ZoningBOX 6.
However, note that all functions are entirely analogous in ZoningBOX 4.
ETS PARAMETERISATION
The only parameterisable screen available by default is
“General”. From this screen it
is possible to activate/deactivate all the required functionality.
Figure 3
. General Screen
Operating Mode
[
Open/Close Mode /
Positional Mode
]
1
: sets the control
mode. When
Positional mode
is selected,
the “Grille Control” sub-tab under
“Zoning” tab is displayed on the left menu. See section 2.2.2 for more details.
1
The default values of each parameter will be highlighted in this document, as follows:
[
default
/rest of options
].
