Z41 Pro / Lite / COM
http://www.zennio.com
Tecnical Support:
http://support.zennio.com
93
Initial Value
: sets which value from the permitted range will be assumed by the
control prior to any button presses. It is always 0 by default.
Minimum Value
: sets which value from the available range will be the minimum
value permitted by the control after a number of presses on the decrease button.
Maximum Value
: sets which value from the available range will be the maximum
value permitted by the control after a number of presses on the increase button.
Short Increment
: sets the increase or decrease to be applied to the current value
on every short press over the increase or decrease buttons, respectively (i.e., the
smaller the increment is, the more presses will be required). It is 1 by default,
except for the case of the 2-byte floating point control, where it is 0.5.
Long Increment
: sets the increase or decrease to be applied to the current value
on every long press over the increase or decrease buttons, respectively (i.e., the
smaller the increment is, the more presses will be required). It is 10 by default,
except for the case of the 2-byte floating point control, where it is 1.
Note
: if the increments configured are too small, certain button touches may not
cause a perceptible value change on the indicator, due to precision restrictions of
the KNX standard.
3.6.2.3.6
Two-button Scene Control
Analogously to the 1-button scene control, 2-button scene controls allows sending the
KNX bus a scene value through the
[General] Scenes: send
object, however in this
case there will be two buttons in the box, each of which can be configured independently.
Through the
Scene
parameter it is possible to assign each of the two buttons (left / right)
the number of the scene to be sent (1
– 64). In addition,
Action
(which permits the
options “Run” and “Run and save”) lets the integrator set whether the device will only
send execution orders for the specified scene (after a short press), or it will possible,
apart from sending execution orders on short presses, to also send save orders for such
scene, in the case of performing a long press on the button
Last, the dropdown list under
Button Icon
sets the icon to be displayed by the buttons.
Note
:
a list with a
ll icons available can be found in document “Z41 Icon list”, available at
www.zennio.com
.
