Z41 Pro / Lite / COM
http://www.zennio.com
Tecnical Support:
http://support.zennio.com
53
•
Maintaining the default option is encouraged. Permanent illumination
may affect adversely the device lifetime, and is only intended for special
circumstances.
Night Mode
: in case of being this mode necessary, this checkbox needs to be
marked, which will incorporate some new parameters:
➢
Backlight Level
: display brightness percentage (0-100%).
➢
Change Theme
: lets select the theme when night mode is active. Options:
“No change” or any of the available themes (see section 2.3.3).
In case of enabling the night mode, some more options can be configured to carry out
the backlight mode control:
Control Object: 1-Bit
: when marked, it will be possible to switch the mode by
writing to a binary object (“
[General] Ilumination
”). It is possible to select which
value should trigger which mode (“0 = Normal Mode; 1 = Night Mode” or “0 =
Night Mode; 1 = Normal Mode
”).
Control object: Scene
: when marked, it will be possible to switch the mode by
writing a certain scene value to “
[General] Scene: Receive
”. Two specific
textboxes will show up to enter what scenes (1 through 64) will trigger each mode.
Backlight Mode after ETS download
: sets
which of the two modes (“Normal
Mode
” or “Night Mode”) will be active after an ETS Download.
Light Up when the Screen is Pressed
: allows changing temporarily the
brightness level when the screen is touched in night mode.
➢
Backlight Level after Touch
: display brightness percentage (0-100%).
➢
Lenght of Lighting
: when the time set in this parameter elapses, Z41 Lite /
Pro / COM will switch to Night Mode (provided that it was not already in this
mode). The range is 1 to 65535 seconds (10 by default).
