Z41 Pro / Lite / COM
http://www.zennio.com
Tecnical Support:
http://support.zennio.com
146
‘PUSH’ NOTIFICATIONS
Z41 Pro / Z41 COM
incorporates the “push” notification function, which consists in
notifying the mobile devices (no matter if the remote control application has been started
or not) about alarm events (see section 3.6.2.5):
Alarm activation
: a box that has been assigned the Alarm function has either
received the alarm trigger value from the KNX bus, or exceeded the cyclical
monitoring period.
Alarm confirmation
: a box with an active alarm has been acknowledged by
the user.
Alarm deactivation
: a box that has already been acknowledged by the user
has also received the no-alarm trigger value. Therefore, the alarm has been
deactivated and acknowledged.
The above notifications are shown on the mobile device (unless “push” notifications are
disabled by the operating system of the device, depending on the user settings) through
messages similar to the following figure, and according to the label assigned to the
involved alarm box:
Figure 154
Push Notification
Notes
:
In case of network unavailability, Z41 Pro / Z41 COM will queue all notifications
related to the alarm events that may take place and will send them as soon as
the network is available.
Queued (unsent) notifications are discarded on external power failures, but not
on KNX bus power failures.
In the unlikely event of a very long network failure, the queue may become out
of space, and therefore further notifications will not be queued.
