Zennio Z41 COM, Configuration Manual

Page: 16 / 21

Z41 COM + Zennio GetFace IP Configuration Guide
http://www.zennio.com Tecnical Support : http://support.zennio.com
16
3.2 SYSTEM WITH MULTIPLE GETFACE IP: PHONE NUMBER (ID)
This parameter is used to associate the video intercom configured in Z41 COM to a
single GetFace IP, so the ca
lls are restricted. If the “Id” of the incoming call does not
match to any of the video intercoms configured in Z41 COM, the call will not be
received. This is useful when there is more than one outdoor unit, so each call is
received in a different Z41 COM box and each one has its call log separately.
If multiple GetFace IP are configured with the same ID, calls from all of them will be
received in the Z41 COM box with a video intercom configured with that ID as shown in
the figure below.
Figure 11 Configuration of multiple boxes with different video intercoms.
3.2.1 Z41 COM CONFIGURATION
The configuration of Z41 COM is the same as indicated in section 2.1 , but also, it is
necessary to configure:
1.
In “
Outdoor Unit 1
”, in the tab “
Configuration
”:
1.1. Define ID: Enabled .
1.2. Outdoor Unit ID: enter the desired text, for example ID_1
ID=””
ID=”1”
ID=”2”
ID=”1”
ID=””
ID=”1”