Touch-MyDesign
Technical Support:
http://zennioenglish.zendesk.com
31
Figure 19
Button T1 (additional buttons)
Therefore, the parameterization and the functionalities available for these additional
buttons working as individual controls are completely analogous to those already
described for the main buttons working as individual controls. Please refer to section
3.3.2 (omitting, if desired, the two initial paragraphs prior to
) for further
information, although note that the following remarks apply:
Being the main button panel organised into pairs (A, B, C and D, in the case of
Touch-MyDesign 8), the main buttons are referred to as A1, A2, B1, B2, etc. In the
case of the additional button panel, the 5 buttons constitute a sole block (“Z”),
because of which the additional individual touch buttons will be referred to as Z1,
Z2, Z3, Z4 and Z5.
As a consequence of the above, the name of any object related to an additional
button will always begin with “[Zi]”, where “i” is the number of the corresponding
button (1-5). Section 3.3.2 refers to object names beginning with “[Xi]”.
3.4.6
INDIVIDUAL INDICATORS
This option permits turning the additional button panel non-functional (thus
performing no actions on button touches) but making use of the corresponding LEDs
as individual indicators whose light statuses permanently depend on the value of the
“[Zi] LED On/Off” binary objects, displayed for that purpose.
