Zennio MAXinBOX 66 v2, Technical Documentation

Page: 1 / 2

© Zennio Avance y Tecnología S.L. Edition 1 Futher information www.zennio.com Page 1/2
MAXinBOX 66 v2
Multifunction actuator with 6 outputs and 6 inputs
ZIOMB66V2 TECHNICAL DOCUMENTATION
FEATURES
•
3 different configurable channels: shutter channels (up to 3) and individual
outputs (up to 6)
•
Outputs suitable for capacitive loads, maximum 140 µF.
•
6 analog/digital inputs.
•
Manual output operation with push button and LED Status indicator.
•
10 logic functions.
•
Output timing.
•
Total data saving on KNX bus failure.
•
Integrated KNX BCU.
•
Dimensions 67 x 90 x 79 mm (4.5 DIN units).
•
DIN rail mounting (EN 50022), with fixing clamp.
•
Possibility of connecting different phases in adjacent outputs.
•
Conformity with the CE directives (CE-mark on the right side).
1. Analog/Digital inputs 2. Upper outputs 3. Output status LED indicator 4. Output control button
5. Programming/test
LED
6. Lower outputs 7. KNX Connector 8. Programming/test
button
9. Fixing clamp
4
1
7
8
3
5
2
6
9
Figure 1: MAXinBOX 66 v2
Programming/Test button: short press to set programming mode. If this button is held while plugging the device into the KNX bus, it enters the safe
mode. If this button is held for more than 3 seconds, the device enters the test mode.
Programming/Test LED: programming mode indicator (red). When the device enters the safe mode, it blinks (red) every half second. The manual mode
is indicated by the green color. During the start-up (reset or after KNX bus failure) and if the device is not in safe mode, it starts a blue blinking sequence.
GENERAL SPECIFICATIONS
CONCEPT DESCRIPTION
Type of device Electric operation control device
KNX supply
Voltage (typical) 29VDC SELV
Voltage range 21..31VDC
Maximum
consumption
Voltage mA mW
29VDC (typical) 4.57 132.53
24VDC¹ 10 240
Connection type Typical TP1 bus connector for 0.80mm Ø rigid cable
External power supply Not required
Operation temperature 0°C .. +55°C
Storage temperature -20°C .. +55°C
Operation humidity 5 .. 95% (No condens.)
Storage humidity 5 .. 95% (No condens.)
Complementary characteristics Class B
Protection class II
Operation type Continuous operation
Device action type Type 1
Electrical stress period Long
Degree of protection IP20, clean environment
Installation
Independent device to be mounted inside electrical panels with DIN rail (EN
50022)
Minimum clearances Not required
Response on KNX bus failure Data saving according to parameterization
Response on KNX bus restart Data recovery according to parameterization
Operation indicator
The programming LED indicates programming mode (red) and test mode
(green). Each output LED indicates its status
Weight 172g
PCB CTI index 175V
Housing material PC FR V0 halogen free
¹ Maximum consumption in the worst case scenario (KNX Fan-In model)