LUMENTO
X3
LED
DIMMING
RGB
CONTROLLER
ZN1DI
‐
RGBX3
Technical
Documentation
© Zennio Avance y Tecnología S.L. Edition 4 Further information
www.zennio.com
Page
1
/
2
1
3
2
6
4
7
5
MAIN FEATURES
Control of RGB LEDs or 3 independent channels.
External power supply required (12-24 VDC).
LEDs test function
KNX BCU integrated
KNX and CE mark
SIZE AND DESCRIPTION
N
Element
1 KNX
Connector
2
KNX Programming button
3
KNX Programming and internal test LED
4
Test button
5
Test LED and Reversed polarity indicator
6
External power supply terminal block
7
LEDs control terminal block
GENERAL SYSTEM SPECIFICATIONS
Type of device
Electric Operation Control Device
KNX Supply
Voltage
29V DC SELV
Voltage range
20…31V DC
Power consumption
145 mW
Bus connection
Typical BUS connector TP1, 0.50mm2 section
External Power Supply
12 – 24V DC
Power Supply cable section
1.5 mm² to 2.5 mm²
Type of control
PWM (150, 300, 488 ó 600 Hz)
Ambient Temperature
0ºC to +45ºC
Storage Temperature
-5ºC a +50ºC
Ambient Humidity
30 to 85% RH (no condensation)
Storage Humidity (relative)
30 to 85% RH (no condensation)
Complementary Characteristics
Class B
Safety Class
II
Operation Type
Continuous operation
Device Action Type
Type 1
Electrical solicitations period
Long
Type of Protection
IP20
Assembly
Independent control assembly device
Connect Lumento as near as possible to both, the LED to dimmer and the external power supply
Power Failure response (bus)
Data saving
Response when restarting (bus)
Data saving
KNX Programming button:
a push button to set the programming mode. If this button is held while plugging the device into the
KNX bus, it goes into secure mode.
KNX Programming and internal test LED:
the red LED indicates programming mode. When the device goes into secure mode, it
blinks red every 0.5 seconds. The blinking blue LED indicates internal test.
Test button
: it tests the functioning of channels connected to the device. Push and hold for 3 seconds to get in/out of the testing
mode.
Test LED and polarity:
tricolored LED that indicates which channel (red=channel 1/R, green=channel 2/G, blue=channel 3/B) is
being tested. White light indicates that the device is in test mode. Orange light indicates reverse polarity in external power supply.
