KLIC-DA LT
Technical Support:
http://zennioenglish.zendesk.com
10
3
ETS PARAMETERISATION
To begin with the parameterisation process of the KLIC-DA interface it is necessary,
after launching the ETS program, to import the database of the product (
KLIC-DA LT
application program).
Next, the device should be added to the project. And then, one right-click on the device
will permit selecting "Edit parameters", in order to start the configuration.
In the following sections a detailed explanation is provided about how to parameterise
the different functionalities of the device in ETS.
3.1
DEFAULT CONFIGURATION
This section shows the default configuration the device configuration starts from. Note
that no communication objects are enabled by default, so the device topology will show
up empty.
Regarding the parameter window, only one main tab (“General”) is shown, containing
one sub-tab called
Configuration
.
The following section describes all the parameters available under Configuration.
Figure 4.
The "Configuration" parameter window, under "General".
