KIPI SC v1.1
Technical Support:
6
1.3
LED INDICATORS
KIPI SC incorporates four LED lights on the top of the device that make it easy to monitor
the status of the buses and to detect typical communication problems, as detailed next.
Figure 2
LEDs
KNX Line Status LED (TP)
: shows the status of the primary bus.
➢
OFF: error or KNX line not connected or not powered.
➢
ON (green) = TP connection OK.
Note
:
the update of the LED status can be delayed a few seconds after the
trigger event, e.g., after the disconnection of the main line.
Ethernet Line Status LED (IP)
: shows the status of the secondary bus.
➢
OFF: error or IP line not connected.
➢
ON (green): Ethernet connection OK
Programming LED
:
➢
OFF = normal operation.
➢
ON (red) = programming mode active.
IP Factory Reset LED:
➢
OFF: normal operation.
➢
ON (red): factory IP is restored (300 ms active).
