IWAC Display v3
Technical Support:
7
1.3
INSTALLATION
IWAC Display v3 connects to the KNX bus through the on-board KNX connector. This
device requires an external 24V DC power supply.
Figure 2.
IWAC Display v3
The main elements of the device are described next.
Programming button (3):
a short press on this button sets the device into
the programming mode, making the associated LED (2) light in red.
Note:
if this button is held while plugging the device into the KNX bus, the
device will enter into safe mode. In such case, the LED will blink in red every
0.5 seconds.
Inputs
(4):
input ports for the insertion of the stripped cables of external
elements such as switches / motion detectors / temperature probes, etc. One
of the two cables of each element need to be connected to one of the slots
labelled “1” to “2”, while the other cable should be connected to the slot
labelled as “C”. Note that all the external input devices share the “C” slot for
3
5
1
4
6
2
8
9
7
1.
KNX connector.
2.
Programming LED.
3.
Programming button.
4.
Inputs.
5.
Touch areas.
6.
OLED display.
7.
NFC antenna.
8.
Auxiliary Power Supply.
9.
Encrypted communication port